Crosley 134857400A manual Features, Common Drying Problems, Cycle Signal Control some models

Features

Cycle Signal Control (some models)

When the Cycle Signal Control is ON, a signal will sound at the end of each cycle and during the Press Saver setting (some models). The volume is adjustable on some models.

Drum Light (some models)

A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light.

Use the drying rack to dry items which should

not be tumbled.

Drying Rack (some models)

Use the drying rack to dry items which should not be tumble dried.

1.Open the dryer door and remove the lint screen.

2.Insert drying rack into the dryer drum. Place the front bar under the lip of the lint screen opening.

3.Place items to be dried on top of rack. Weight should not exceed 10 lbs. Leave space between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack.

4.Select a timed dry setting best suited for items being dried. Use only the Air Fluff (no heat) temperature setting for items containing plastic, foam rubber, rubber- like materials, feathers or down.

5.When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause damage to the dryer.

Common Drying Problems

Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.

PROBLEM	POSSIBLE CAUSES	SOLUTIONS	PREVENTIVE MEASURES
Greasy, oily	•Fabric softener sheet.	•Rub fabric softener stains with bar soap. •Add a few bath towels to small loads for proper
stains		Rinse and rewash.	tumbling.

•Some "silk-like" fabrics should be air dried. •Use proper drying temperature.

•Place fabric softener sheet on top of load before starting the dryer.

Lint•Overloading. •Overdrying causes static

electricity.

•Lint screen not clean when cycle began.

•Lint is attached to "pills."

•Reduce load size and rewash using	•Do not overload dryer.
liquid fabric softener in the final rinse.	•Use fabric softener in washer or dryer to reduce
•Or, add a fabric softener sheet and	static electricity.
tumble without heat.	•Remove items when they are slightly damp to
•Use lint brush or roller to remove lint.	avoid overdrying.
	•Check that lint screen is clean and in place.

Pilling

(Fibers break off, ball up and cling to fabric.)

•Pilling is normal with synthetic and permanent press fabrics. This is due to abrasion from normal wear.

•Use a lint brush or shaver to remove pills. •Use fabric softener to lubricate fibers.

•When ironing, use spray starch or fabric finish on collars and cuffs.

•Turn items inside out to reduce abrasion.

Shrinking	•Overdrying.	•Irreversible condition.	•Follow fabric care label directions.
			•If shrinking is a concern, check load often.
			•Remove items while slightly damp.
			•Block knits into shape.
			•Lay flat to complete drying.
Wrinkling	•Overloading.	•Reduce load size and tumble at medium	•Do not overload dryer.
	•Leaving items in dryer	or low heat for 5-10 minutes.	•Remove items as soon as cycle ends.
	after cycle ends.	•Remove items immediately. Hang or fold.

9