Electrolux LAVAMAT 52810 manual If the wash result is not satisfactory

Problem	Possible cause	Remedy
Conditioner has not	The conditioner insert in the
been rinsed in, com-		Clean the detergent drawer,
partment w for condi-	compartment for additives	insert the conditioner insert
	has not been correctly in-
tioner is filled with		firmly.
	serted or is blocked.
water.
		Wait until the DOOR indica-
	The door is locked.	tor goes out and the END in-
		dicator illuminates.
		The programme will continue
The door cannot be		when the power cut has end-
opened when the wash-	There has been a power cut.	ed.
ing machine is switched	(All the indicators have gone	To remove the washing:
on.	out.)
		If water can be seen in the
	The door remains locked for
		appliance, first empty the
	approx. 2 minutes.
		water before opening the
		door (see section “Carrying
		out an emergency drain”).
The washing is badly	Perhaps too many items	Observe the maximum load
creased.	were loaded.	volume.

If the wash result is not satisfactory

The washing is grey and there are limescale deposits in the drum

•Too little detergent was used.

•An incorrect detergent was used.

•Individual stains were not pre-treated.

•The programme or temperature was not set properly.

There are grey stains on the washing

•Items that were soiled with ointments, fats or oils were washed using too little detergent.

•The wash temperature used was too low.

•A common cause is that conditioner – in particular the type in con- centrated form - has come in contact with the washing. Wash out such marks as soon as possible and exercise care when using the said conditioner.

Foam can still be seen following the final rinse

•Modern detergents can cause foam to be created even during the fi- nal rinse. In spite of this, the washing has been sufficiently rinsed.

20