Electrolux EWX 14450 W Machine fills then empties immediately, There is water on the floor

32 electrolux what to do if...

Malfunction

The machine fills then empties immediately:

Possible cause

●The end of the drain hose is too low.

Solution

●Refer to relevant paragraph in “water drainage” section.

The machine does not empty and/or does not spin:

● The drain hose is	● Check the drain hose
squashed or kinked. E20	connection.
● The drain pump is	● Clean the drain pump.
clogged. E20
● The Rinse Hold or No	● Select the Drain or Spin
Spin option has been	programme.
selected.

There is water on the floor:

●The laundry is not evenly distributed in the drum.

●Too much detergent or unsuitable detergent (creates too much foam) has been used.

●Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.

●The drain or inlet hose is damaged.

●The cap on the emergency emptying hose has not been replaced after cleaning the pump.

●Redistribute the laundry.

●Reduce the detergent quantity or use another one.

●Check the water inlet hose connection.

●Replace it with a new one.

●Put the cap back on the emergency emptying hose and place the latter back in its seat.

Unsatisfactory washing results:

●Too little detergent or unsuitable detergent has been used.

●Stubborn stains have not been treated prior to washing.

●The correct temperature was not selected.

●Excessive laundry load.

●Increase the detergent quantity or use another one.

●Use commercial products to treat the stubborn stains.

●Check if you have selected the correct temperature.

●Reduce the laundry load.