Inspecting When to Remove Shipping Bolts

[ ] Warranty Registration Card [ ] Majestic Literature

[ ] Hoses have washers in both ends.

Brass Pressure Regulators installed on back of

appliance.

√ INSPECT CONTENTS [ ] Owners Manual Brass Pressure Regulators

[ ] (Must be installed on hot and cold water inlet. Failure to do so can damage the internal components and cause water damage for which the installer/owner will be re- sponsible!)

REMOVING THE FOAM DRUM SUPPORT REPLACING THE METAL BOTTOM PAN.

WARNING!!! IN ORDER TO REMOVE THE

FOAM DRUM SUPPORT AND REPLACE THE

METAL BOTTOM PAN, THE BOTTOM OF THE

MACHINE MUST BE ACCESSED. SHIPPING

BOLTS MUST REMAIN IN THE APPLIANCE

WHILE ACCOMPLISHING THIS STEP IN THE

PREPARATION PHASE OF THE INSTALLATION.

Inspecting WHEN TO REMOVE SHIPPING BOLTS!

WARNING!!! TIPPING THE MACHINE TO POSITION IT FOR USE MUST BE DONE WITH THE SHIPPING BOLTS STILL IN THE MACHINE!

TIPPING THE MACHINE WITHOUT SHIPPING BOLTS, CAN CAUSE THE INNER DRUM TO IMPACT OTHER INTERNAL PARTS, THUS DAMAGING THEM. POSITION THE MACHINE AS CLOSE AS POSSIBLE TO IT’S FINAL POSITION AND THEN REMOVE SHIPPING BOLTS.

ATTENTION:

DO NOT TAKE

OUT SHIPPING

BOLTS UNTIL

MACHINE IS

POSITIONED

WITHIN A FEW

INCHES OF ITS

FINAL INSTALL-

TION POINT. TIP-

PING THE UNIT

OR MOVING IT

WITHOUT SHIP-

PING BOLTS

WILL VOID WAR-

RANTY.

Page 2