Warning — to reduce the risk of fire, electric shock, or injury to person, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
OPERATING INSTRUCTIONS
1.Make sure Washer is turned off. (Indicator light should be off).
2.Separate clothes into cottons, permanent press and delicates.
3.Close the Washer door. You will hear a click when it is correctly closed.
4.Add detergent to the center compartment of the dispenser (2). Use low
5.Choose a Wash program by turning the washer knob clockwise to the desired setting on the control panel. (See chart on page 15)
6.If you have a light load or ½ load of clothes, press the ½ load button.
7.For delicates only (wool, silk, etc.) if you do not want the drum to spin, press the no spin button. Keep in mind that the clothes will retain a fair amount of water.
8.Review these steps and check all the settings on the control panel before starting the machine.
9.Press the Power button. The indicator light will come on and in a few seconds, you will hear the cycle begin.
10.When the Washer has completed the cycle, the machine will stop automatically, although the indicator light will remain on until you manually press out the Power button.
Note: The door switch of the Washer is electronic and locks automatically during the Wash cycle. You must wait for 2 minutes after the Wash cycle has stopped to open the door. Please do not try to force the door open. Breaking of the door handle is not covered by warranty.
STARTING THE WASHER
Starting your washer in the right way is important for the quality of your wash, to help prevent future problems and enhance life expectancy of your appliance. Once you have loaded your washer and added the detergent together with any fabric conditioner, always check that:
1)The door is closed correctly.
2)The plug is secured in the socket.
3)The water supply is turned on.
Choose the desired program
The program is selected according to the type of garments that need to be washed. To choose a program, refer to the table on page 15, then:
1)turn Washer knob until the selected program is aligned with the mark on the knob,
2)turn Spin speed knob to the desired position,
3) if necessary use buttons ½ LOAD and NO SPIN
4)lastly, press the Power button.
At the end of the wash cycle...
Turn the washer off by pressing Power button. You can now open the washer door safely. After having removed the freshly cleaned laundry, leave the door open to allow air circulation inside the drum. Remember that, in the event of a power failure, or should the washer switch itself off, the program chosen will remain in memory.
14 | Washer Owner’s Manual |