Hotpoint BHWD 149 Indicator lights, Starting a wash cycle, Wash cycle phase indicator lights

Page 9

Indicator lights

The indicator lights provide important information. This is what they can tell you:

Wash cycle phase indicator lights

Once the desired wash cycle has been selected and has begun, the indicator lights switch on one by one to indicate which phase of the cycle is currently in progress.

Door locked indicator light

GB

If this indicator light is on, the appliance door is locked to

 

prevent it from being opened accidentally; to avoid any

 

 

damage, wait for the indicator light to switch off before you

 

open the appliance door.

 

! If the START/PAUSE indicator light (orange) flashes

rapidly at the same time as the function indicator light,

this indicates a problem has occurred (see “Troublesho-

oting”).

Wash

Rinse

Spin

Dry

End of wash cycle

Note: as soon as a drying level or time period has been set, this indicator light illuminates to indicate that the selected wash cycle will be followed by a drying phase.

Note: during the “Drain” phase, the indicator light corre- sponding to the “Spin” cycle phase will illuminate.

Function buttons and corresponding indicator lights When a function is selected, the corresponding indicator light will illuminate.

If the selected function is not compatible with the pro- grammed wash cycle, the corresponding indicator light will flash and the function will not be activated.

If a function which is incompatible with another function selected previously, only the most recent selection will remain active.

Starting a wash cycle

1.Switch the washing machine on by pressing the ON/OFF button. All the indicator lights will turn on for a few seconds, then only the indicator lights relative to the selected programme settings will remain lit and the START/PAUSE indica- tor light will flash.

2.Load the laundry and close the door.

3.Set the WASH CYCLE knob to the desired programme.

4.Set the washing temperature (see “Personalisation”).

5.Set the drying cycle if necessary (see “Personalisation”).

6.Measure out the detergent and washing additives (see “Detergents and laundry”).

7.Select the desired functions.

8.Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in

a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle.

9.At the end of the wash cycle the indicator light will switch on. The DOOR LOCKED indicator light will switch off, indicating that the door may be opened. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the Washer-dryer off by pressing the ON/OFF button.

9

Image 9
Contents WASHER-DRYER Instructions for useInstallation Unpacking and levellingElectric and water connections Earth 65 100 cmBlue Brown LiveFirst wash cycle Technical data Instructions for the fitter Door Mounting Accessories FigUsing the Drilling Template Description of the Washer-dryer and starting a wash cycle Standby modeControl panel ON/OFF buttonWash cycle phase indicator lights Indicator lightsDoor locked indicator light Starting a wash cycleWash cycles Table of wash cyclesReady to Wear Setting the drying cycle Setting the temperaturePersonalisation FunctionsDetergent dispenser drawer Detergents and laundryGarments requiring special care Preparing the laundryGeneral safety Precautions and tipsDisposal Opening the porthole door manuallyCleaning the Washer-dryer Care and maintenanceCleaning the pump Cutting off the water and electricity sup- GB pliesTroubleshooting ProblemPossible causes / Solutions Machine wont spin properly Machine leaks from the dispenserMachine smells Machine door cannot be opened Assistance GuaranteeAfter Sales Service Page 195085380.04