Hotpoint WF 561 P manual Personalisations, Setting the temperature Variable Temperature, Functions

Personalisations

Setting the temperature (Variable Temperature )

Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8).	G B
The temperature can be lowered, or even set to a cold wash (Cold).

Setting the spin speed (Variable Spin speed)

Turn the VARIABLE SPIN SPEED knob to set the spin speed for the programme selected. The maximum spin speeds for each programme are as follows:

Programmes	Maximum spin speed
Cottons	1600 rpm
Synthetics	800 rpm
Wool	600 rpm
Silk	no

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting “No Spin”.

The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each programme.

Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.

When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency.

If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning. The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

Function	Effect	Comments		Enabled with
				programmes:
	Delays the	Press the button repeatedly until the LED corresponding to
		the desired delay is turned on.
	start of the	The fifth time the button is pressed, the function will be		All
	wash by up to 9	disabled.
Delay
	hours.	N.B.: Once you have pressed the START button, the delay can
Timer		only be decreased if you wish to modify it.
	Allows for an
	impeccable wash,			1, 2, 3, 4,
	visibly whiter
				5, 6, 7, 8.
Super	than a standard
Wash	Class A wash.
	This option	When this function is set, programmes 6, 7, 8, 11 and "Rinses &		All
	reduces the
		Slow Spin" will end with the laundry left to soak (Anti-crease)
	amount of			programmes
		and the Rinse cycle phase LED will flash.
	creasing on			except for
		- to conclude the cycle, press the START button;
	fabrics, making			1, 2, 9, 10 and
		- to run the draining cycle alone, set the knob to the relative
	them easier to			Pump Out.
Easy Iron		programme	and press the START button.
	iron.
Extra	Increases the	Recommended when the appliance has a full load or with large		1, 2, 3, 4,
	efficiency of			5, 6, 7, 8 and
		quantities of detergent.
Rinse	the rinse.			Rinses.

9