First wash cycle | Hotpoint WDD guide

As the colours of the wires in the lead may not corre-

GB	spond with the coloured markings identifying the termi-
	spond with the coloured markings identifying the termi-
	nals in your plug, proceed as follows:
	Connect Green & Yellow wire to terminal marked E or
	or coloured Green or Green & Yellow.
	Connect Brown wire to terminal marked L or coloured
	Red.
	Connect Blue wire to terminal marked N or coloured
	Black.
	If a 13 amp plug (BS 1363) is used it must be fitted with
	a 13 amp fuse, either in the plug or adaptor or at the
	distribution board.
	If you are in any doubt about the electrical supply to
	your machine, consult a qualified electrician before use.
	How to connect an alternative plug:
	The wires in this mains lead are coloured in accordance
	with the following code:
	BLUE	NEUTRAL (N)
	BROWN	LIVE (L)
	GREEN & YELLOW	EARTH (E)

	GREEN &
	YELLOW
	BROWN	13 ampere fuse
	BROWN
	BLUE	CROSS-BAR
		CORD GRIP

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle .

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

!The Washer-dryer should not be installed in an out- door environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

!When the Washer-dryer is installed, the mains socket must be within easy reach.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dange- rously compressed.

!The power supply cable must only be replaced by an au- thorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.