Using the Controls –
STEP 5
Soak Only (select models)
Provides approximately 33 minutes of alternating periods of soaking with brief agitation at slow speed. At the end of the cycle, the Cycle Selector dial must be manually set to a wash cycle or spin cycle to drain the washer. Avoid extended soaking.
Spin Only
Provides a spin to remove more water from the load.
Rinse and Spin
Use for loads that need rinsing only or to add rinse- added fabric softener to a load.
Electronic Control Models
STEP 6
Select Options
Extra Rinse
When the knob is in the On position, an additional rinse at the end of all cycles is provided to more completely remove laundry additives, suds, perfumes, etc.
End of Cycle Signal
The end of cycle signal will sound once the cycle is completed. On select models, the end of cycle signal can be canceled by setting the switch to Off.
Power Off
To cancel the cycle and turn off the washer, turn the Cycle Selector dial to Power Off and push the dial in.
STEP 7
Start the Washer
To start the washer, press the cycle selector dial.
Changing a Cycle
If an incorrect cycle has been accidentally selected:
1.Press the cycle selector dial.
2.Turn the cycle selector dial to the desired cycle.
3.Set the desired options for the cycle.
4.Press the cycle selector dial. The Wash indicator lights stop flashing and the new cycle starts.
Canceling a Cycle
To cancel a cycle:
1.Press the cycle selector dial.
2.Turn the cycle selector dial to Power Off and push the dial in.
To drain the washer:
1.Select the Rinse and Spin or Spin Only cycle.
2.Press the cycle selector dial. The Spin light illuminates and the washer starts the rinse or spin.
11