Maytag LAT8106, LAT1916, LAT8026, LAT9206, LAT8016, LAT8006 manual Before You Call

Page 10

Before You Call (continued)..................................

Check thes( )oints if ,our washer...

Unevenly distributed load. Redistribute the load, close the lid and pull knob out. Check for leveling. Be sure water level is acceptable for load size.

Plug cord into live electrical outlet.

Check fuse or reset circuit breaker.

Turn the control knob to proper cycle and pull knob out to start the washer. If

Stops

equipped with buttons, be sure they are fully depressed.

Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless lid is closed.

This may be a pause or soak period in the cycle. Wait briefly and it may start.

The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop fill operations for your safety. Call for service.

o..***., e e*.***o, e e*t 6o.*.*• *, e e J.*_ e ..6o*. •••*.o e •*.Q• e o•, o..**, i •**.l e •*.Q e*..._*.••**.••*.. ••*.. e**.• 1*..oe*.o***.o•*..•**

 

• Make sure hose connections are tight.

Leaks Water

• Make sure end of drain hose is correctly inserted and secured to drain facility.

 

Avoid extended soaking - soak for 30 minutes or less.

Avoid overloading.

Be sure washer is leveled properly as outlined in installation manual.

Is NoisyWeak floors can cause vibration and walking.

Be sure robber feet are installed on leveling legs.

Turn both faucets on fully,

If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and not between settings.

Fills withMake sure temperature selection is correct.

the WrongMake sure hoses are connected to correct faucets and inlet connections. Be

Temperaturesure water supply is regulated correctly. Flush water line before filling

Waterwasher.

Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate.

Disconnect hoses and clean screens. Hose filter screens may be plugged.

For further help, cull Muytug Customer Assistance: U.S. 1-800-688-9900 or Canada 1-800-688-2002

9

Image 10
Contents GUI Welcome Read this manual for bestImportant Safety Instructions Extra Heavy select models approx Select Cycle Features may vary according to modelOntrolsance Select modelsStep Water TemperatureStep Select Start WasherSpecial Features Fabric Softener DispenserOperating Tips Washer Before the load and be sure wash water is above 65 FStoring the Washer Care and CleaningWater Use Before You Call Check these oints if your washerBefore You Call To Receive Warranty Service Automatic Washer Warran ty