Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is located at the back of the appliance.The appliance is supplied with a 13amp plug supplied, a 13amp ASTA approved (BS1362) fuse must be used.
Should the plug need to be replaced for any reason.
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow | : Earth |
Blue | : Neutral |
Brown | : Live |
The wire coloured green and yellow must be connected to the terminal marked with the letter "E" or by the earth symbol or coloured green and yellow.
The wire coloured blue must be connected to the terminal "N" or coloured black.
The wire coloured brown must be connected to the terminal marked "L" or coloured red.
Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
WARNING:
A cut off plug inserted into a 13 amp 
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safety.
Permanent connection
In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point.
146 1250 00
Green and yellow
E
N
Blue
13A
Brown
Cord clamp
24