Zanussi IZ 141 W, IZ 141 S, IZ 161 W, IZ 161 S manual Electrical connection, Permanent connection

Page 27

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

Mod

Prod. No

Ser. No

P0042•N

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

The power supply cable must be easily accessible after installing the appliance.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

N

13 A

L

BROWN

BLUE

P1041

CORD CLAMP

 

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

27

Image 27
Contents Washing Machine Installation Child SafetyUse Contents Your New Washing Machine Ecological hintsInterest of the environment Detergent dispenser drawer Child safety featureDescription of the Appliance Door locked lightControl Panel Drain only Wash Choice buttonOptions button DisplaySTART/PAUSE button SKIP/RESET buttonSelecting a special programme Delay buttonDelay Start only without the Outdoor Sports option Delay Start with the Outdoor Sport optionProgramme phase indicator lights Measure out the detergent Switch the machine onOperating Sequence Load the laundrySelect the Super Rinse or AA40 option Select the temperatureSelect the Delay Time Select the desired optionsEnd of programme How to change a programme during its cycle1000g = 1 kg «JETSYSTEM» washWhich form? Which detergent?Important Notes Wash Care SymbolsWashing programmes Maintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working 0870 5 Symptom Possible causesCustomer Care Department Guarantee ConditionsStandard guarantee conditions European guaranteeTechnical Specifications Installation InstructionsInstallation on a Suspended Floor UnpackingPositioning Water inlet Water drainageAppliance must be connected to a cold water supply Special conditions LevellingPermanent connection Electrical connectionFrom the Electrolux Group. The world’s No choice