Zanussi F 1256 W manual Start the programme, Altering a programme, Interrupting a programme

Page 10

DELAY

START

8 H

12 H

4 H

2H WASHING END

7.Start the programme

Before starting up the machine check that:

the appliance is plugged in

the water supply tap is turned on

the drain hose is correctly and securely positioned

the door and the detergent dispenser drawer are closed.

To start the selected programme, press the START/PAUSE button; the corresponding light stops flashing.

The WASHING light illuminates.

The door light comes on to indicate that the door is locked. The machine starts operating.

START

PAUSE

If you have chosen a delayed start, the machine will begin the countdown.

8. Altering a programme

You can alter the programme before it starts.

When the programme has started, you can only reset it by turning the programme selector dial to O and then you can select the new programme.

The washing water remains in the tub. Start the new programme by depressing the START/PAUSE button.

9. Interrupting a programme

Depress the START/PAUSE button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.

10.Cancelling a programme

Turn the selector dial to O to cancel a programme which is running. Now you can select a new programme.

11.Opening the door after the programme has started

First set the machine to PAUSE by pressing the START/PAUSE button.

The door can be opened when the light of the porthole has gone out.

If the door does not open, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning.

If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to “O”. After about 3 minutes the door can be opened (pay attention to the water level and temperature!).

12. At the end of the programme

The machine stops automatically.

The door can only be opened after the light of the porthole has gone out.

Release of the lock is also indicated by the illumination of the END light.

Turn the programme selector dial to “O” to switch the machine off.

Remove the laundry from the drum and carefully check that the drum is empty.

If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.

10

Image 10
Contents Washing Machine Child Safety InstallationUse Contents Ecological hints Your New Washing MachineInterest Environment Door locked light Child safety featureDescription of the Appliance Detergent dispenser drawerControl Panel Programme information Programme progress displayProgramme selector dial WoolWorn once 30\30’ DrainSpin HandwashOperating Sequence Altering a programme Cancelling a programmeStart the programme Interrupting a programmeMeasure out the detergent Measure out the fabric softenerAt the end of the programme Washing Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing Programmes Washing symbol Type of laundry Dial positionLoad Description Possible Max Washing symbol Type of laundryWash programme Degree of soil OptionsMaintenance and Cleaning Cleaning the water inlet filter Emergency emptying outSomething Not Working 0870 5 Service & Spare PartsCustomer Care European guarantee Guarantee ConditionsStandard guarantee conditions ExclusionsInstallation Instructions Technical SpecificationsUnpacking Installation on a Suspended FloorPositioning Water drainage Water inletAppliance must be connected to a cold water supply Special conditions LevellingInterest of the environment Electrical connection Permanent connectionFrom the Electrolux Group. The world’s No choice