It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe designed to carry the exhaust from a fuel burning appliance.
P0055 |
Door reversal
To make it easier to load or unload the laundry the door can be reversed.
This operation must be carried out by your local Service Force repair agent (tel 08705 929929).
This will be a chargeable option.
Operate as follows:
-Remove the door by unscrewing the two screws (1) fastening the hinge to the cabinet (Fig. A).
-Remove the safety catch (2) and the plug (3) by bending the two fastening tags (Fig. A).
Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry its “exhaust” at least beyond the kitchen units; preferably outside the kitchen.
In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. Therefore, in case of a permanent hose fitted to an exterior wall or ceiling, it must have an exhaust capacity of at least 150 m3/h.
2
3
P0283
1 
4
A
If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption.
If the hose is completely squashed, the safety cut- outs with which the machine is fitted may operate.
Stacking kit
It should be possible to stack your new dryer on top of your washing machine.
Please contact your local Service Force Centre for further advice.
P0280
-Refit the safety catch (2) and plug (3) on the door by reversing their positions (Fig. B).
| 2 |
4 | 1 |
| 3 |
P0748 | B |
-Remove the plastic plate (4) by unscrewing the two fastening screws (Fig. A).
-Refit the plastic plate (4) on the opposite side (Fig. B).
-Refit the door by screwing in the two screws (1) which fasten the door to the cabinet (Fig. B).
15