Operating Sequence, Modifying the programme

Operating Sequence

Before using your tumble dryer for the first time, we recommend you place a few damp cloths inside the appliance and dry for 20 minutes.

There may be dust inside a brand new tumble dryer.

Drying

1.Connect the appliance.

2.Open the door.

After each use

•Switch the appliance off by releasing the ON/OFF button . The mains-ON light goes out.

•Clean the filters (see page 9).

•Empty the water reservoir (see page 10).

Important!

If the drying programme has to be stopped before it reaches the end, we recommend that you turn the

P1149

P1108

programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance.

Modifying the programme

To change a programme which is running without opening the door, first depress the ON/OFF button

and then turn the time selector dial to the required

3.Load the items one at a time, shaking them out loosely.

4.Close the door. Please check the laundry does not get caught between the door and filter.

5.Press the ON/OFF button : the mains-ON light comes on.

6.Select the drying time.

7.If required, press the low temperature button or the Cool Tumble button .

8.Press the Start button : the machine starts operating .

The drum turns alternately in both directions during drying.

All drying programmes end with a 10 minute cooling phase (position on selector dial).

The machine stops automatically at the end of this phase.

time. Press the ON/OFF button again.

9.Release the ON/OFF button (the mains-ON light goes out) and immediately remove the laundry.