Malfunction | Possible cause | Solution | |
|
| ||
When pressing a button, • Washing protection. | • Turn the programme knob to | ||
the corresponding | After the start of the pro- | ||
button flashes several | gramme, the option can no | OFF. Set the programme again | |
times. | longer be set. |
| |
Drying cycle ends | • Not enough washing | • Select time programme or | |
shortly after programme | loaded | higher drying level (e.g. | |
starts. END | or washing loaded is too | EXTRA DRY instead of CUP- | |
light illuminated. | dry for selected programme. | BOARD). | |
Programme inactive, | • Water reservoir is full. | • Empty the water reservoir, | |
Condenser | then start programme with | ||
light illuminated. |
| START/PAUSE button. | |
|
|
| |
Drying cycle lasts an | • Lint filter clogged. | • Clean lint filter | |
• Heat exchanger clogged | |||
unusually long time. | • Clean heat exchanger. | ||
with lint. | |||
Note: | • DELICATE is only suitable for | ||
• DELICATE button pressed | |||
After around 5 hours | and load volume too big. | use with loads of up to 3 kg! | |
the drying cycle ends | • Reduce load volume. | ||
• Load volume too big. | |||
automatically (see | • Laundry must be adequately | ||
• Laundry insufficiently | |||
„Drying cycle complete“) | |||
| predrained. |
| |
|
|
| |
If you are unable to identify or solve the problem, contact your local Service Centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information.
1206 |
Important:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
17