Maytag MAH5500B operating instructions ? Eplace Interior Light, Toring The Clothes Washer

Page 10
TORING THE CLOTHES WASHER

TORING THE CLOTHES WASHER

Washers can be damaged if water is not removed from hoses and internal components before storage. Prepare the washer for storage as follows:

Select the cottonlsturdy and quick setting and add one cup of bleach to the detergent dispenser without clothes in the tumbler. Run the clothes washer through a complete cycle.

Turn the water faucets off and disconnect the inlet hoses.

Disconnect the clothes washer from the electrical supply and leavethe washer door open to let air circulate inside the tum- bler.

If the washer has beenstored in below-freezing temperatures, allow time for the washer to thaw out prior to use.

For information on long-term storage or storage of your washer during extreme cold temperatures,

call Maytag Customer Service toll-free at 1-888-462-9824.

U.S. customers usingTTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.

?EPLACE INTERIOR LIGHT

Instructions for replacing the bulb:

I) Unplug or disconnect the clothes washer from the electrical power supply.

2)Open the door.

3)Unscrew the light bulb counter clockwise from the socket.

4)Replace the bulb with a 10 watt candelabra base light bulb and rotate clockwise.

5)Plug in or reconnect clothes washer to the power supply.

Clothes washer door swing direction can be changed using the following procedure:

I) Swing door fully open and support it while removing four hinge screws (which hold hinges to door assembly).

2)Move the door to a work surface and transfer four door screws to the opposite side of the door assembly.

3)Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side).

4)Remove hinge and bracket from cabinet by moving them up and clown to a position where they are released.

5)Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.

6)Compare top hinge and top bracket to bottom hinge and bottom bracket for correct hinge assembly position.

7)Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.

8)Support door in fully open position on hinge side and drive four screws to securely attach hinges to door assembly.

9)Close door and check to see that clothes washer operates properly.

 

 

 

 

Counter

Sunk Screw

 

r

,

,

 

_

 

 

,,

,,.

..,

 

 

_

Door

ll_.

 

 

D

q

_

Screws

''_/

 

 

','

i

 

 

iJ

 

 

 

 

i_

!

*

=

 

 

 

,r

,,

te

 

 

 

9

Image 10
Contents ABLE CONTENTSSAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSWELCOME PERATING INSTRUCTIONS StepLOAD THE CLOTHES WASHER PERATING INSTRUCTIONS CONT Wash/RinseStep 3J SELECT WASH/RINSE WATER TEMPERATURESOptions SELECT THE SIGNALStep 7j Step 6jdoorlocked esmatedtimeATER ESTIMATED TIME DISPLAYDETERGENT COMPARTMENT EATURESDETERGENT AUTOMATIC DISPENSERBLEACH COMPARTMENT EATURES CONTSOFTENER COMPARTMENT ARE AND CLEANING CLEANING THE DISPENSER? EPLACE INTERIOR LIGHT TORING THE CLOTHES WASHEREFORE You CALL CONTFreshening EFORE YOU CALL CONTYour Washer Sloshing or gurgling water sound PERATING SOUNDSClicking/draining sounds when washer is started reduced spin speed after achieving a higher spin speedMAYIAG UESTIONS & ANSWERSrlEP rUrlE MAYFAG rlEPFUrlETo Receive Warranty Service WASHER WARRANTYWhat is not covered by these warranties