Before You Call | ....... . |
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care proce- dures, see the enclosed Laundering Tips booklet.
Check these points if your Maytag Neptune TM washer...
• Use Max Extract option.
Load Is Too Wet at • Try using a high efficiency detergent to reduce sudsing.
End of Cycle• Load is too small. Very small loads (one or two items) may not spin out completely.
• ....o** | **** | ,**o | ool*** | e*oo* o | ooo | *** | I | * *** | • • o* | • ***... | ,.... |
Leaks Water
Won't Spin or
Drain
Stops
• o...,.*o*.* | Qoo* |
| Tub is |
| Completely |
| Full of Suds |
....o***......oo• | i......•oo4 |
Fills with
the Wrong Temperature Water
..*•.......**o......*..**...,
•Door firmly closed.
•Make sure hose connections are tight.
•Make sure end of drain hose is correctly inserted and secured to drain facility.
•Avoid overloading.
•Use high efficiency detergent to prevent
•Check fuse or reset circuit breaker.
•Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
•Close the door and push the START/STOP button. For your safety, washer will not tumble or spin unless the door is closed.
•After pressing the START/STOP button, it may take a few moments before the clothes washer begins to spin. The door must lock before spin can be achieved.
•See "Tub is Completely Full of Suds" below.
•Plug cord into live electrical outlet.
•Check fuse or reset circuit breaker.
•Turn the control dial to proper cycle and push the START/STOP button to start the clothes washer. If equipped with buttons, be sure they are fully depressed.
•Close door and push the START/STOP button to start the clothes washer. For your safety, washer will not tumble or spin unless door is closed.
•This may be a pause or soak period in the cycle. Wait briefly and it may start.
•Check screens on inlet hoses for obstructions. Clean screens periodically.
•*''''''''**''''''" | •***'''''''*•* | " |
•Run the clothes washer through another complete cycle using cold water.
•Reduce detergent amount for that specific load size, soil level and water hardness.
•Use high efficiency or low sudsing detergent specially formulated for front load washers.
......o•**o | o | Io.ol | ooe•l | oooo | • | •*.o | •**'''''" | * |
•Turn both faucets on fully.
•Check that the temperature selector button is fully depressed.
•Make sure temperature selection is correct.
•Make sure hoses are connected to correct faucets and inlet connections. Flush water line before filling washer.
•Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate.
•Disconnect hoses and clean screens. Hose filter screens may be plugged.
•When warm rinse is selected, only the final rinse will be warm. The first two rinses will be cold.
•While the washer is filling for cold or warm wash temperatures, both hot and cold water will go through the dispenser as the automatic temperature control feature checks
incoming water temperatures. This is normal.
• |
10