Haier HDY-C70 ME manual Trouble shooting, Following must be confirmed before calling for service

Trouble shooting

The following must be confirmed before calling for service:

Problem	Possible Cause
	● Is the power supply plugged in and switched on.
	● Plug another appliance into the wall socket to
The dryer does not	test if there is power.
switch on	● Check if a drying program has been set;
	● the Start/Pause button has been pressed;
	● The water collection box is full;
The dryer does not	●Is the door closed tightly;
switch on and the	●The loaded laundry has reached the requirements
screen displays "End"	for the drying setting.
	●Is there a load in the drum.
	●Have you selected the correct drying option;
	●Has the filter screen been cleaned ;
	●Is the condenser blocked;
The drying result is	● Does the amount of the loaded laundry
not up to standard	exceed the rated load;
and the drying cycle	● Has the loaded laundry been spun dry;
takes too long.	●Is the vent duct blocked;
	● Does the surface of the inside of the drum
	have a deposit layer forming, if so clean the
	drum interior;
	The remaining time will be adjusted and corrected
	continuously and automatically based on the
The remaining time	following factors:
	●Type of laundry;
display is halted, or the
remaining time displayed	●Loaded amount;
is skipping	●The moist degree of laundry;
	●Ambient temperature;
	The automatic adjustment is a normal operation.

Trouble shooting

Prompt and Alarm Information

In case of an improper operation or problem with the machine when it operates, the code corresponding to the problem will be displayed on the screen:

Code	Category	Cause	Solutions
E2	Trouble code	There is no change in	Contact a professional
		the temperatures of
			serviceman
		the laundry in the tub
E5	Trouble code	The thermal sensor	Contact a professional
		open-circuited or short
		circuited	serviceman
E6	Trouble code	Drain pump fails	Contact a professional
			serviceman