Maintenance

1. Turn of the water and electricity supply			2. Unplug the machine during cleaning and
after every wash. Open the door to pre-			maintenance. Use a soft cloth dampened with
vent the formation of moisture and odors.			soapy liquid to clean the machine case and rub-
If the washing machine is left idle for a			ber components. Do not use corrosive or abra-
long period, drain any remaining water in			sive chemicals or solvents.
the machine and replace the drainage
hose.

3. Clean the detergent compartment			4. Cleaning the Filter (once a month)
regularly. For the detergent compartment
similar to figure (a), raise the compartment			Press the lower edge of the filter compartment
slightly to remove and replace after cleaning.			cover to open; (Fig1-2)
			Remove the filter by turning counterclockwise;
			(Fig3)
			Flash clean with running water;
			Filter replacement is the reverse of removal. Cau-
			tion: Attention shall be paid to ensure that the fil-
			tion: Attention shall be paid to ensure that the fil-
			ter is replaced correctly to avoid possible leakage.

Fig (a)	fig.1	fig.2	fig.3

5.To prevent block- ages to the water sup-

ply or the ingress of contaminants, clean the water inlet and in- l e t w a t e r f i l t e r regularly.

7.If the washing machine is left idle for a long period turn off the water and electricity supply and open the door slightly to prevent the formation of moisture and odors.

6.If the machine is to be moved a distance location, replace the vibration mounting locks which were re- moved during installation as shown below.

Remove the	Replace the rubber	Insert the bolts.
	plugs.
back cover.

Tighten the bolts with the	Replace the back
spanner provided.	cover.