Haier HWM80-68B user manual Disposal after washing

Page 16

Disposal after washing

After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine.

Please first pull off the power plug from the receptacle before cleaning.

Please take off the detergent box and wash it with water

1.How to take it off: Pull it upwards slantingly and gently.

2.How to install: Put it in from the top slantingly, then push it in to the right position.

The lint filter must be used during washing.

It must be cleaned in time after each using

Lint filter:

1.Pull it up to dismantle. 2.Push it down to install.

3.Clean the filter screen after washing.

 

 

Install

 

 

Dismantle

Dismount

Install

Clean

The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it with brush every two months.

If the cabinet is dirty, wipe it with wet cloth Do not flush it directly with water. Wipe it with neutral detergent.

Do not wipe it with thinner, petrol, alcohol etc.

Pe

tro

l

 

Thinner

 

 

Alcohol

 

 

 

 

 

 

1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose). 2.Do not store water in the washing machine for a long period. Drain the water completely

after each using.

3.Be sure to pull off the power plug before maintenance. 4.Hang up the power cord and drain hose.

5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (about 1 hour), then close the top lid.

Answers to question

Common phenomena

Phenomena

Explanation

 

 

The spinning is intermittent when it starts.

It is to balance the laundries to avoid slanting.

 

 

Push the SPIN button, but it doesn't act.

The program is setting the drain time. A certain

period is needed before it starts spinning.

 

 

 

The pulsator pauses during water filling in washing and rinsing.

It is to avoid splashing during water filling.

There may be some water flowing out of the drain

It is the water remained in the machine during the

hose in the first use of the machine.

ex-factory performance inspection.

In adding water, the pulsator performs stirring slightly

It is to soak the laundries more completely.

 

 

Image 16
Contents Full automatic washing machine Contents Meaning and description of the symbols Names of the partsSafety precautions Wet laundries on the control panelTro Installation and adjustment Install the bottom plateAdjust the installation position After adjustment, fasten the nutHow to change the direction of the drain hose Install the lint filterUsage of the drain hose Install the water inlet hose Install the water inlet pipeDismount the water inlet hose Preparation before washing Pay attention to followings before washing the laundriesHow to use the whitener How to use the washing powderPut in the laundries Add the detergent and softenerDescription of the function of the operation buttons Use the operation knobs and buttonsReserve button START/PAUSE button ProgramPush the select button to select suitable procedure Close the top lid Finish washing Procedure selection methodPush the START/PAUSE button Disposal after washing Trouble-shooting No water inletSpecification Packing list