Steps for Installation
•Select a suitable location for the washer on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer.The washer must be placed at room temperature.You must not place washer where the temperature is at below freezing.
For this machine having ventilation openings in the base, make sure the openings must not be obstructed by a carpet.
Installing Your Washer
Read installation instructions carefully before installation.
1.Do not use water inlet hoses without a flat washer on each end.The washer in the coupling has to be placed firmly. Flat water inlet hose washers are preinstalled in each end of the water inlet hoses.
New
NOTE: You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause damage to the valve.
Cold water inlet hose
Hot water inlet hose
2.Connect the hot and cold water inlet hoses to the hot and cold water faucet.
12