Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.

Install the lint filter

After opening the package,please take out the lint filter from the document bag,install it to the overflow filter of the wash tub.See to the figure.

Overflow filter

Lint filter

Usage of the drain hose

The drainage shall be smooth with the drain hose.

1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.

2.Do not tramp or press the drain hose.

<10cm

3.If the drain hose is too long, cut it at mid point.
	To make smooth drainage, cut the front end of
	the hose slantingly.
4.If extra drain hose is needed , please make			> 30mm
			> 30mm
separate purchase. The inner diameter of		the
extra hose shall not less than 30mm, and		the	<1.5m
			<1.5m
length shall not exceed 1.5m.
If	the extra hose is too long, cut it either
at	point A or B.

A B

Filling water from wash water-filling entrance

The appliance is to be connected to the water mains using new hose-sets and that old hose- sets should not be reused.

Insert the water inlet hose into the water-filling

entrance, then push the water-filling jointer into

the entrance on the control panel. (To dismantle

the water inlet pipe, just push the control handle

as indicated in the figure and pull it out)

Water inlet hose

Water-filling jointer

Push

Control handle Wash water-filling entrance