Before Using
Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function.
Make sure all Nuts and Bolts are tight.
Use only Bench Grinders that are fully compatible with the Bench Grinder Pedestal Stand. The Bench Grinder Pedestal Stand fits most Harbor Freight Tool Bench Grinders, but you should always check for sure before using.
Use of the Pedestal Stand is for use with bench grinders only.
Assembly
Your Pedestal Stand will require assembly prior to use. It is important that you read the entire manual to become familiar with the unit BEFORE you set up the Stand. Before assembling your Stand, be sure that you have all parts described in the Parts List and Parts Diagram on the last pages of this manual.
Set out all parts on a clear work surface prior to assembly.
Warning: | Use only bench grinders that are fully compatible with the Bench Grinder Pedestal |
| Stand. Using bench grinders which do not fit this stand may result in harm or serious |
| injury to the operator. The Bench Grinder Pedestal Stand fits most Harbor Freight |
| Tool Bench Grinders, but you should always check for sure before using. |
| Use the Pedestal Stand for bench grinders only. |
Step 1) | Mount the Base (3) to a |
| Base, or into cement for safety and stability. A rubber mat should be placed between |
| the Base (#3) and the mounting surface to reduce vibration. The Mounting Holes on |
| the Base (3) are 3/8” in diameter. Insert appropriate screws (not included) through the |
| Base (3) and into a flat and secure surface. The mounting surface must be able to |
| support the weight of the Stand as well as the Grinder and work pieces during use. |
Step 2) | Insert the Column (#2) into the hole in the Base (3). Insert a Bolt (4) into each |
| hole in the Base (3) and tighten them firmly against the Column (2). |
Step 3) | Slide the Work Table (1) into place on top of the Column (2). Thread one Bolt (4) through |
| each hole in the WorkTable. Tighten the Bolts (4) until they are firmly against the Column. |
Step 4) | Make certain that all Bolts (4) are tightly in place and that the Stand is secure. |
Step 5) | Secure the bench grinder to the Work Table (#1) with six appropriate |
| size bolts, washers and nuts (not included). |
Step 6) | Make sure that the Pedestal Stand and the bench grinder are secure before using. |
SKU 42986 | For technical questions, please call | Page 3 |