Care and Cleaning, Inside, Outside | Frigidaire 131882000 (9907)

Care and Cleaning

Clean lint screen after every load.

Do not store or place laundry products on top of dryer at any time. They can damage the finish or controls.

To reduce risk of fire or serious injury to persons or property, comply with the basic warnings listed in Important Safety Instructions, pages 2-3, and those listed below.

•Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards.

•Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur.

Inside

•Clean the lint screen after every load. Lint build-up in the screen restricts air flow, which causes longer drying times. The screen is located at the bottom of the door opening. Remove by pulling straight up. Remove the lint and replace the screen.

•Occasionally a waxy build-up may form on the lint screen from using dryer- added fabric softener sheets. To remove this build-up, wash the lint screen in warm, soapy water. Dry thoroughly and replace. Do not operate the dryer without the lint screen in place.

•If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser. Remove cleanser residue before drying the next load.

•Every 18 months an authorized servicer should clean the dryer cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard.

Outside

•Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers.

•If the cabinet becomes stained, clean with diluted chlorine bleach [1/2 cup (120 ml) in 1 quart (.95 liter) water]. Rinse several times with clear water.

•Remove glue residue from tape or labels with a mixture of warm water and mild detergent. Or, touch residue with the sticky side of the tape or label.

•Before moving the dryer, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent damage to floor.