LG Electronics TD-V10155G, TD-V10159G, TD-V10150G manual Pedestal Installation Instructions

Page 15

Part 4 ACCESSORIES INSTALLATION

Pedestal Installation Instructions

The pedestal accessory includes:

• Drawer divider (1)	•	Wrench (1)
• Screws (18) †	•	Retainers (4) ††

3 Place the dryer on the pedestal. Make sure the front and back feet are in the correct positions. The dryer feet will fit into the innermost positions as shown.

For dryer

For washer/combo

† Dryer installation only uses 8 screws †† For dryer only

Tools Needed for Installation:

• Phillips-head screwdriver

• Wrench (supplied)

To ensure safe and secure installation, please thoroughly follow the instructions below.

1 To set the dryer to the same height as the washer, fully retract the leveling feet of the dryer by turning them counterclockwise, then turn them clockwise 1-1/2 turns.

NOTE: The appliance and pedestal assembly must be placed on a solid, sturdy, level floor for proper operation.

Retract fully	Then loosen
	1-1/2 turns

2 Insert the T-clip of the 4 retainers into the dryer base as shown. Press up on the back of the clip and pull outward to lock into place.

T-clip

Retainer

4 Make sure the screws on the pedestal align with the holes in the retainers, then install 4 screws at each corner to securely attach the appliance to the pedestal.

NOTE: If the screws are not installed properly, noise and vibration may result.

Move the appliance to the desired location.

5	Loosen the locknuts on all 4 leveling feet of the
	pedestal until you can turn them with the wrench.
	Turn clockwise to raise or counterclockwise to lower

until the pedestal is level and all 4 feet are solidly against the floor.

Raise

Lower

6 Securely tighten all locknuts by hand.

NOTE: Noise and vibration may result if locknuts are not tightened.

Be sure to connect the appliances to all water, power, or gas lines and draining or venting connections before operation.

If there is excessive vibration during the first operation after installation, slightly adjust the leveling feet.

Locknut

1 4

Image 15

Contents V10159G-TD V10155G-TD V10150G-TD Gas Dryer Table of Contents Accessories Part 1 SpecificationsSeeking Warranty Assistance Part 2 Important Warranty and Safety InstructionsImportant Safety Instructions What to do if YOU Smell GAS Positioning the Dryer Part 3 Initial Steps for Installing Your DryerDoor Venting System Clean old ducts before installing this dryerElectrical Plug Connections Connection of Gas SupplyConfirming Heat Source in Electric Dryers Preparation of the DryerOperation Confirming Heat Source in Gas DryersPart 3 Initial Steps for Installing Your Dryer Stacking Kit Installation Instructions Part 4 Accessories InstallationPedestal Installation Instructions Part 5 GAS Requirements and Instructions Exhaust Requirements and Instructions Part 6 Exhaust Requirements and MaintenanceCleaning the Lint Screen Exhaust and Dryer MaintenanceExplosion Hazard Power ButtonPart 7 Operating Your Dryer Fire HazardSensor Dry Temp Cycle SelectionTime Change Button Estimated Time RemainingOption Buttons Child LockManual Dry Temp When using Air DryType of Load Default Time Minutes Temp. ControlDry Level Start / Pause ButtonStarting your dryer To use a manual dry cycle Clean the door and its openingTE2 Part 8 Troubleshooting GuideQuestion What to Do TE1ProblemThere is Lint on my Clothes ProblemIt takes too long for my clothes to dry Contenido Accesorios Parte 1 EspecificacionesParte 2 Garantía E Instrucciones DE Seguridad Importantes Advertencia QUE Hacer EN Caso DE Oler GAS Secadora Parte 3 Pasos Iniciales Para LA Instalación DE SU SecadoraProcedimiento para Invertir la Puerta PasoPaso 3 Conexión del Sistema AdvertenciaPaso 5 Conexión Elèctrica De GasConfirmación de la Fuente de Calor en Secadoras Eléctricas De la Fuente de CalorPaso 8 Flujo de Aire Confirmación de la Fuente de Calor en Secadoras a GasAdvertencia Parte 4 Instalaciòn DE Accesorios Instalacion de la secadora Cinta de tipo doble-cara Instrucciones y Advertencias Parte 5 Requerimientos E Instrucciones Sobre EL GASRequerimientos e Instrucciones del Escape Parte 6 Requerimientos Y Mantenimiento Sobre EL EscapeLimpieza de la Malla de Pelusa Peligro de Incendio Parte 7 Usando SU SecadoraBotón de encendido Peligro de ExplosiónTiempo Selección del cicloBotón de cambio de tiempo Tiempo rest. estimadoSugerido Control paternoBotones Opción Temperatura TiempoAlarma Arranque de su secadora Botón de arranque / pausaLimpiar el filtro atrapapelusa MantenimientoPregunta Qué Hacer TE1 Parte 8 Guía Para LA Solución DE ProblemasParte 8 Guía Para LA Solución DE Problemas Parte 8 Guía Para LA Solución DE Problemas