Electrolux - Gibson P/N 131883600 (9907) manual Drying Procedures, Load the dryer

Page 4

Drying Procedures

Follow fabric care label instructions.

J J_

,,_ ',_

Place small items in a mesh bag.

Fill dryer drum 1/3 to 1/2 full.

Follow the guidelines below for preparing the load for drying.

Read the Operating Instructions card for operating your specific model.

Always read and follow fabric care labels and laundry product labels.

To reduce the risk of fire, electrical shock, or injury to persons, read

Important Safety Instructions, pages 2-3, before operating this dryer.

. Prepare items for drying.

Dry items of similar fabric, weight and construction in the same load.

Separate dark items from light-colored items. Separate items that shed lint from those that attract lint. If an item sheds lint, turn it inside out.

Besure buckles, buttonsand trim are heatproof and won'tdamagethe drum finish. Closezippers, fasten hooks and Velcro®-Iike fasteners. Tie strings and sashesto prevent snagging and tangling.

If possible, turn pockets inside out for even drying.

Check for stains which may not have been removed in washing. Dryer heat may permanently set some stains. Repeat stain removal process before drying.

Placesmall items in a mesh bag to prevent tangling and for easy removal.

2.Check that lint screen is clean and in place.

. Load the dryer.

The average load will fill the drum 1/3 to 1/2 full. Items need room totumble freely for even drying and lesswrinkling. Do not overload dryer.

When drying large items, dryonly2 or 3 at atime. Filloutthe load with small and medium sized items.

Fordelicate or very small loads, add 2 lint-free towels for better drying, less wrinkling, and to prevent grease stains caused by fabric softener sheets.

Do not overd ry items. Overdrying can causewrinkling, shrinkage, harshness, and a build-up of static electricity, which can produce more lint.

If desired, add a dryer fabric softener sheet.

4.Close the dryer door and set dryer controls (some models). See Operating Instructions card for your specific model controls.

5.Turn cycle selector clockwise to the desired setting.

. Start the dryer.

PushStart Button for 2seconds or turn the STARTknob clockwiseto ON, hold for 1-2 seconds and release.

To add or remove itemswhen the dryer is running, open the door. The dryer will always stop when the door is opened. Allow the drum to come to a complete stop before reaching inside.

To restart dryer, close the door then push the Start Button for 2 seconds or turn the STARTknob clockwise to ON, hold for 1-2 seconds and release.

The dryer will not start if the cycle selector is in the OFFposition.

7.When the cycle ends, remove items immediately and hang or fold. If load is removed before the cycle ends, turn cycle selector to OFF.

Image 4
Contents Gibson Important Safety Instructions ContentsProduct Registration GAS Dryers Protect ChildrenPrevent Injury PlugDrying Procedures Check that lint screen is clean and in placeLoad the dryer Prepare items for dryingFeatures Common Drying ProblemsProblem Possible Causes Solutions Preventive Measures Drum Light some modelsCare and Cleaning Iiii!iiAvoid Service Checklist Gibson Dryer Warranty Your Gibson product is protected by this warranty