OPERATING INSTRUCTIONS
Cycle Settings, continued
max (on select models)
Recommended for durable fabrics and towels.
high
Recommended for most cotton fabrics.
normal
Recommended for wrinkle free, easy care, lightweight fabrics and bulky loads.
low
Recommended for delicate fabrics.
air dry
This setting (no heat) should only be used with a Timed Dry cycle to dry items containing feathers, down, foam rubber, plastics or
Dryness Level (Auto Dry)
To change the preset level, press the dry level button to scroll to the degree of dryness desired.
To protect your fabrics, not all dryness levels are available with every cycle. If a dry level is not appropriate for the cycle, it cannot be selected.
The dry level selected for the cycle will be remembered and recalled each time that cycle is selected in the future.
To return to factory settings, press these two buttons at the same time and hold until the signal sounds.
NOTE
To change the dry level after the cycle starts, press pause, adjust the setting and press START to resume the cycle.
Select the normal dry level for most Auto Dry cycles.
Occasionally a load may seem too damp or
Select damp for items you wish to partially dry before hanging or ironing.
Options
To select an option, press options until the indicator for the desired option flashes, then press select. If an option is not available for a cycle, the indicator will not light. Follow the same steps to delete an option.
shrink guard (on select models)
NOTE
To change the options after the cycle starts, press pause, adjust the setting and press START to resume the cycle.
Select shrink guard to lower the initial drying temperature to protect fabrics from overdrying.
wrinkle release
Select wrinkle release if the dried load might not be removed promptly at the end of the cycle. The dry load will continue tumbling without heat to help reduce wrinkling. When Chime is selected, a beep will be heard periodically. The load may be removed any time during wrinkle release.
damp alert (on select models)
For loads that contain some items you plan to hang dry, flat dry or iron, add the damp alert option to any Auto Dry cycle. A signal will sound when the load has reached the damp dryness level to remind you to remove those items to hang dry, dry flat or iron dry. Open the door, remove those items, close the door and press the START button to continue drying the remaining items.
chime
A signal will sound at the end of the cycle (and periodically during wrinkle release) if this option is selected. The signal has an adjustable volume level or can be turned off.
10