Important Safety Instructions, con’t
•ALWAYS disconnect the dryer from the electrical supply before attempting any service or cleaning. Failure to do so can result in electrical shock or injury.
•Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur.
•To prevent injury, do not reach into the dryer if the drum is moving. Wait until the dryer has stopped completely before reaching into the drum.
PREVENT INJURY AND DAMAGE TO THE DRYER
•All repairs and servicing must be performed by an au- thorized servicer unless specifically recommended in this Owner’s Guide. Use only authorized factory parts.
•Do not tamper with controls.
•Do not install or store the dryer where it will be exposed to the weather.
•A thermal limiter switch automatically turns off the motor in the unlikely event of an overheated situation (electric dryers only). A service technician must replace the thermal limiter switch after correcting the fault.
•Failure to comply with these warnings could result in seri- ous personal injuries.
The instructions appearing in this Use and Care Guide are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating and maintaining any appliance.
Drying Procedures
To reduce the risk of fire, electric shock or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in this Use and Care Guide before operating your dryer.
(Mesh bag not included.)
Clean the lint filter after
every load.
1.Prepare load for drying.
•Dry items of similar fabric, weight and construction in the same load.
•Separate dark items from
•Check for stains which may not have been removed in washing. Repeat stain removal process and wash again before drying. Dryer heat may permanently set some stains.
•Place delicate or small items in a mesh bag.
•Be sure buckles, buttons and trim are heatproof and won’t damage the drum finish. Close zippers; fasten hooks and
2.Check that the lint filter is clean and in place.
3.Load the dryer and close the door.
•Load items loosely. The average wet load will fill the drum 1/3 to 1/2 full. Items need room to tumble freely for even drying and less wrin- kling.
•If desired, place a dryer fabric softener sheet on top of the load at the beginning of the cycle.
•To save energy and time and avoid uneven drying and wrinkling, do not overload the dryer.
•When drying large items, dry only two or three items at a time. Fill out the load with small and medium sized items.
•For delicate or very small loads, add two or three similar items to im- prove tumbling action.
4.Select the appropriate cycle and settings for each load.
•See Operating Instructions for your specific model.
5.Start the cycle.
•To add or remove items when the dryer is running, open the door. The dryer will stop when the door is opened. Allow the drum to come to a complete stop before reaching inside.
•Close the door and press Start to resume the cycle.
6.When the cycle ends, remove items immediately and hang or fold.
4