Function Test Sequence

1.Press and hold Select and Cancel buttons simultaneously for 6 seconds to reset the control. The buzzer will sound.

2.Immediately after, rotate cycle selector knob 5 turns counter-clockwise to the second position from the bottom. Press and hold the Options and Cancel buttons simultaneously for 2 seconds. The control will enter test mode, the buzzer will sound 3 times and all LED’s will rapidly flash.

After entering the test mode, the cycle selector knob can now be rotated to select the following tests:

Rotate the cycle selector knob clockwise from the starting position:

0 turns:	All LED’s will flash.
1 turn:	Drive motor runs; heat source is on. Drying LED is lit. “H” and the control thermistor reading will toggle
	back and forth in the display.
2 turns:	Drive motor runs; heat source is off. Cool Down LED is lit and “AF” (Air Fluff) is displayed.
3 turns:	Drive motor runs; heat source is off. Drying and Cool Down LED’s are lit and numbers appear in the
	display showing moisture sensor readings. Opening the door (press in on door switch plunger) and placing
	a finger on the both moisture sense bars at the same time will make the numbers decrease. In controls that
	do not have a digit display, the More Dry LED should be ON. Opening the door (press in on door switch
	plunger) and placing a finger on the both moisture sense bars at the same time will make the Damp LED
	come on.
4 turns:	Drive motor runs; heat source is off.
	Key test:
	a. When the Temperature key is pressed, all the temperature LED’s should light.
	b. When the Dryness key is pressed, all the dryness level LED’s should light.
	c. When the Options or Select key is pressed, all the Option LED’s should light.
	d. When the Start/Pause key is pressed, all the cycle status LED’s should light.
	e. When the Cancel key is pressed, all the cycle status LED’s should light.
5 turns:	Drive motor runs; heat source is off. Cool Down LED is lit. Control thermistor reading is displayed.
6 turns:	Drive motor runs; heat source is on. Drying LED is lit. Control thermistor reading is displayed.
7-11 turns:	All LED’s will flash

To EXIT test mode, press and hold the Select and Cancel buttons simultaneously for 6 seconds or disconnect power from dryer. Dryer will be reset for regular operation.