Before you call for service… | GEAppliances.com |
Troubleshooting Tips
Save time and money! Review the charts on the following pages, or visit GEAppliances.com. You may not need to call for service.
Problem | Possible Causes | What To Do |
Dryer doesn’t start | Dryer is unplugged | • Make sure the dryer plug is pushed completely into |
|
| the outlet. |
|
|
|
| Fuse is blown/circuit breaker | • Check the house fuse/circuit breaker box and replace |
| is tripped | fuse or reset breaker. NOTE: Most electric dryers use |
|
| two fuses/breakers. |
|
|
|
Dryer doesn’t heat | Fuse is blown/circuit breaker is | • Check the house fuse/circuit breaker box and replace |
| tripped, the dryer may tumble | both fuses or reset both breakers. Your dryer may tumble |
| but not heat | if only one fuse is blown or one breaker is tripped. |
|
|
|
| Gas service is off | • Make sure gas shutoff at dryer and main shutoff are |
|
| fully open. |
|
|
|
Dryer shakes or | Some shaking/noise is normal. | • Move dryer to an even floor space, or adjust leveling legs |
makes noise | Dryer may be sitting unevenly | as necessary until even. |
|
|
|
Greasy spots on clothes | Improper use of fabric softener | • Follow directions on fabric softener package. |
|
|
|
| Drying dirty items | • Use your dryer to dry only clean items. Dirty items can |
| with clean ones | stain clean items and the dryer. |
|
|
|
| Clothes were not | • Sometimes stains which cannot be seen when the clothes |
| completely clean | are wet appear after drying. Use proper washing |
|
| procedures before drying. |
|
|
|
Lint on clothes | Lint filter is full | • Clean lint screen before each load. |
|
|
|
| Improper sorting | • Sort lint producers (like chenille) from lint collectors |
|
| (like corduroy). |
|
|
|
| Static electricity can attract lint | • See suggestions in this section under STATIC. |
|
|
|
| Overloading | • Separate large loads into smaller ones. |
|
|
|
| Paper, tissue, etc., left in pockets | • Empty all pockets before laundering clothes. |
|
|
|
Static occurs | No fabric softener was used | • Try a fabric softener. |
|
| • Bounce® Fabric Conditioner Dryer Sheets have been |
|
| approved for use in all GE Dryers when used in |
|
| accordance with the manufacturer’s instructions. |
|
|
|
| Overdrying | • Try a fabric softener. |
|
| • Adjust setting to LESS DRY or DAMP DRY. |
|
|
|
| Synthetics, permanent press | • Try a fabric softener. |
| and blends can cause static |
|
|
|
|
Inconsistent | Type of heat | • Automatic drying times will vary according to the type |
drying times |
| of heat used (electric, natural or LP gas), size of load, |
|
| types of fabrics, wetness of clothes and condition of |
|
| exhaust ducts. |
11
Safety Instructions
Operating Instructions
Troubleshooting Tips