GE 4500 About reversing the door, Reversing the Door, Tools needed Standard #2 Tape-tipped

Page 9

About reversing the door.

Reversing the Door

Tools needed:

 

 

■ Standard #2

■ Tape-tipped

■ Needle-nosed

Phillips screwdriver

putty knife

pliers

1 Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about half way into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in untapped holes.

2 Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT.

3 Rotate the door 180°. Insert it on the opposite side of the opening by moving the door IN and DOWN until the top hinge and the bottom hinge are resting on the top screws inserted in step 1.

4 Remove the remaining screws from the side of the opening from which the door was removed. With these screws secure each hinge at the bottom. Tighten the two top screws of each hinge. Reinsert the plastic plugs on the side from which the door was removed.

9

Safety Instructions

Operating Instructions

Troubleshooting Tips

Customer Service

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Models Type 333 453 473 475 DryersGE & You, a Service Partnership Service TelephoneCongratulations You Are Now Part of the GE Family Flammable vapors and liquids Do not store or use gasoline or otherVicinity of this or any other appliance Gas supplier Clear the room, building or area of all occupantsYour Laundry Area Loading and Using the Dryer section Read and follow this Safety Information carefullyAbout the dryer control panel Important Clean the lint filter each time you use the dryer Control SettingsDrying Cycles for Models Type 453, 473, 475 Drying Cycles for Models TypeAutomatic Cycle Signal-On some models About your dryer featuresExtra Care Option-On some models SensorDryReversing the Door About reversing the doorTools needed Standard #2 Tape-tipped Putty knife PliersCare and Cleaning of the Dryer Sorting and Loading HintsFabric Care Labels Venting the Dryer Before you call for service… To dry Clothes take too longClothes are wrinkled Clothes shrinkPage GE Will Replace GE Dryer Warranty For customers in the U.SWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYService Satisfaction Service Telephone Numbers
Top Page Image Contents