Kenmore 134914900 manual Care and Cleaning, Features, Drying Rack, Inside

Page 5

Features

Hace the front bar under ttqe lip of the lint screen opening,

Care and Cleaning

Clean lint screen after every load.

Cycle Signal

A signal will sound at the end of the cycle and periodically during Wrinkle-Rid. Drum Light

A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light. Reversible DryerDoor

Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. Refer to the INSTALLATIONINSTRUCTIONSfor directions on changing the door.

Drying Rack

Use the drying rack to dry items which should not be tumble dried.

I.Open the dryer door and remove the lint screen.

2.Insert drying rack into the dryer drum. Place the front bar under the lip of the lint screen opening.

3.Place items to be dried on top of the rack. Weight should not exceed 10 Ibs. Leave space between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack.

4.Select Time Dry. Use only the No Heat option for items containing plastic, foam rubber, rubber-like materials, feathers or down.

5.When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause damage to the dryer.

To reduce risk of fire or serious injury to persons or property,

comply with the basic warnings listed in important Safety Instructions and those listed below.

Before cleaning the dryer interior, unplug the electricalpower cord to avoid electrical shock hazards.

Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur.

Inside

Clean the lint screen after every load. Lint build-up in the screen restricts air flow, which causes longer drying times. The screen is located at the bottom of the door opening. Remove by pulling straight up. Remove the lint and replace the screen.

CAUTION- Risk of Fire - A clothes dryer produces combustible lint. The dryer must be connected to an exhaust outdoors. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the outdoor exhaust opening and in the surrounding area.

Occasionally a waxy build-up may form on the lint screen from using dryer- added fabric softener sheets. To remove this build-up, wash the lint screen in warm, soapy water. Dry thoroughly and replace. Do not operate the dryer without the lint screen in place.

Image 5
Contents Ryer Ecadora Contents Cont 14-30RUse this way ONL Y Correct Use this way ONL Y Important Safety Instructions Prevent Injury Drying ProceduresCheck that lint screen is clean and in place Load the dryer Press Start to begin the cycleFeatures Care and CleaningDrying Rack InsideProblem Possiblecauses Solutions Common Drying ProblemsDryer does not start Dryer runs but wont heat SeeDrying ProceduresHot or smells hot Excessive WrinklingKenmore Appliance Warranty