Eurotech Appliances EDV278EL owner manual Electrical Connections, Connecting a 3-WIRE Power Cord

ELECTRICAL CONNECTIONS

The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device. Connection to a permanently wired supply point must be made only by a qualified electrician.

As supplied: Single-phase, 230 V, 60 Hz, 3300 Watt heater, 30 A fuse required

CONNECTING A 3-WIRE POWER CORD

WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box.

You will need a 3-wire power supply cord with three No. 10 copper wires and a matching 3-wire receptacle of NEMA Type 10-30R, as illustrated below:

	This blade connects	Ring	Spade terminals
		terminals
	to this conductor.
			with upturned ends
		Neutral/
		Ground
Neutral/Ground	3/4” UL-listed	(white)
	strain relief

Follow the steps below to connect a 3-wire power cord:

1.Turn the power off at the breaker/fuse box.

2.Remove terminal block cover.

3.Use the strain relief attached below the terminal block opening.

4.Loosen or remove center terminal block screw.

5.Connect neutral/ground (white) wire of power supply cord to the center, silver-colored terminal screw. Tighten screw.

6.Connect the other wires to outer screws.

7.Tighten the strain relief screws.

8.Replace terminal box cover on back of dryer.

9.Plug dryer into wall receptacle.

10.Turn power on at breaker/fuse box.

The numbers in the illustration below correlate to the step numbers.

4

5

6

7

6