Electrolux EDC47130W user manual Something not working, Malfunction Possible cause Solution

electrolux something not working 15

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.

During machine operation it is possible that

the red Start/Pause pilot light flashes to indicate that the machine is not working.

Once the problem has been eliminated, press the Start/Pause button to restart the program. If after all checks, the problem persists, contact your local Service Centre.

Malfunction	Possible cause	Solution
Dryer does	• Mains plug is not plugged in or fuse is not	• Plug in at mains socket
not work	working correctly	Check fuse in fuse box (domestic installation)
	• Loading door is open	• Close loading door
	• Have you pressed the START/ PAUSE button?	• Press the START/PAUSE button again
Drying results	• Wrong program selected	• Select a different program the next time
unsatisfactory		you use the dryer (see “Overview of
		programs” section).
	• Lint filter clogged	• Clean lint filter
	• Condenser unit clogged with lint	• Clean condenser unit.
	• Incorrect load size	• Observe recommended loading volumes.
	• Ventilation slots in base area covered up	• Uncover ventilation slots in base area.
	• Residue on inside surface of drum or drum ribs	• Clean inside surface of drum and drum ribs
Loading door	• Fine strainer not in place and/or large mesh	• Install fine strainer and/or snap large mesh
does not close	filter not locked in place.	filter into place
When pressing	• Washing protection	• Turn the program knob to OFF.
a button, the	After the start of the program, the option can	Set the program again
corresponding	no longer be set
button flashes
several times.
Drying cycle	• Not enough washing loaded or washing	• Select time program or higher drying level
ends shortly	loaded is too dry for selected program.	(e.g. EXTRA DRY instead of CUPBOARD).
after program
starts. END
light illuminated
Program	• Water Tank is full	• Empty water tank, then start program
inactive, Water		with START/PAUSE button.
tank full light
illuminated
Drying cycle	• Lint filter clogged	• Clean lint filter
lasts an	• Condenser unit clogged with lint	• Clean condenser unit
unusually long	• DELICATE button pressed and load volume	• DELICATE is only suitable for use with loads
time.	too big	of up to 3 kg!
Note: After	• Load size too big	• Reduce load size
around 5 hours	• Laundry insufficiently pre-drained	• Laundry must be sufficiently spun and/or
the drying cycle		adequately pre-drained
ends automatically
(see “Drying cycle
complete“)