Installation Instructions | Blomberg DV16540NBL00 specs

3Installation Instructions

A WARNING - Risk of fire

•The clothes dryer (“appliance‘) installation must be performed by a qualified installer.

•Install the appliance according to the manufacturer’s instructions and local codes.

•Do not install a clothes dryer with flexible plastic venting materials. If flexible metal

(foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Flexible venting materials are known to collapse, be easily crushed, and trap lint. These conditions will obstruct the clothes dryer’s airflow and increase the risk of fire.

ATo reduce the risk of severe injury or death, follow all installation instructions.

SAVETHESE INSTRUCTIONS

Electrical connection

Connect the appliance to a grounded outlet protected by a fuse or circuit breaker of suitable capacity.

Dryer shipped with cord to ﬁt this type 4 -wire receptacle

4-wire receptacle

(14 -30R)

If yo u have 3-wir e receptacle, like this , a 3-wire dryer cord mu st be purc hased locall y.

3-wire receptacle

(10 -30R)

3-Wire Electrical Connection

If your receptacle is a 3-wire receptacle as shown below, you must obtain a 3-wire dryer cord. A dryer cord can usually be found at your local hardware supply, electrical supply or home center. Cord should have closed loop or upturned end wire terminating connectors.

3- wire receptacle

( 10-30R)

Typical 3- Wire Dryer Cord 240V/30 amp NEMA 10-30 Type SRDT

A If the dryer is installed in a mobile home, recreational vehicles, new branch-circuit installations or in areas where local codes do not permit grounding, only a 4-wire power supply cord shall be used.

To change the cord:

1.Make sure that the dryer is not plugged into any power outlet.

B DO NOT plug end of dryer power cord into a live receptacle before connecting dryer power cord to dryer terminals and closing junction/splitter box as described below.

B DO NOT repair old power supply cords. Power cord must be changed only by a qualified person. There is a risk of electric shock!

2.Remove the screw from the cover of the junction box located at the top rear of the dryer.

3.Remove the red, white and black wire from the terminal block.

4.Remove the green ground wire from the ground terminal.

5.Loosen the strain relief clamp holding the 4-wire cable.

6.Thread the 4-wire cable out through the strain relief clamp.

7.Thread the new 3-wire dryer cord through the strain relief clamp.

8 - EN