Avanti WDB101 instruction manual Assembling the legs, Assembling the Bottom Support Frame

Page 4

Your Washer / Dryer Stacking Bracket is designed to accommodate both top loading or front loading washing machines. Follow the assembly instructions below to assemble the bracket to fit your specific washing machine type. Images shown in this instruction guide are for assembly for use with a TOP‐Load washer.

Step 1: Assembling the legs:

When using with a TOP‐ Load washer.

Assemble the rear legs by screwing together all three sections of the rear leg.

Part D – Rear Leg (Bottom section)

Part P – Front / Rear Leg (Middle section) Part E – Front / Rear Leg (Top section)

Assemble the front legs by screwing together all three sections of the front leg.

Part F – Front Leg (Bottom section)

Part P – Front / Rear Leg (Middle section) Part E – Front / Rear Leg (Top section)

When using with a FRONT‐Load washer.

Assemble the rear legs by screwing together only the bottom and top sections of the rear leg

(Parts D & E).

Assemble the front legs by screwing together only the bottom and top sections of the front leg

(Parts F & E).

Step 2: Assembling the Bottom Support Frame.

We suggest that you put the U shaped bottom support frame (Part A) in a vertical position. As this will allow you to insert the legs and the Shelf / Frame support clips with ease.

a)Lay the Bottom support frame (Part A) on its back with each side bar facing upwards.

b)Insert each of the rear legs (assembled in step one) into the holes at both rear corners of the support frame.

c)Using the Shelf / Frame support clips (Part I) insert the plastic tapered clips into the appropriate grooves on each leg. (See the image).

d)Slightly press the bottom support frame downward on to the support clips.

e)Insert each of the FRONT legs in the remaining corner holes of the support frame and repeat Step C.

f)Stand the unit upright to continue the remainder of this assembly.

g)Press each corner downward firmly to ensure the support frame is fully locked into position.

4

Image 4
Contents Manual DE Instrucciones Part I 2 additional pieces are supplied as spares Assembled Dimensions Assembling the legs Assembling the Bottom Support FrameAssembling the Middle Support Frame and Logo / Support Bar Assembling the Top ShelfInstalling the Anti‐Tip Safety Bracket Installing Your Avanti Dryer Model D110 to the top shelf