Spin process
1 | Put the laundries in properly | |
2 | Put the gland in properly |
|
3 | Close the inner and outer cover of the spin tub | |
4 | Do you need | |
| has an effect that can remove the surplus liquid dirt, | |
It works in a way as follows:
Spin |
|
| |
|
| spinning | |
Spin for about |
|
| |
1~2 minutes | Fill water | for | Spin for about |
Remove most of | |||
the foam extra | about 1 minutes | 1~2 minutes | |
detergent liquid. |
| Remove the detergent | |
|
| ||
|
| liquid remained | |
Note: If there needs no | , set the duration for |
spinning directly. |
|
The effect is best when the laundries quantity is below | 80% of the rated value. |
5
Take the laundry out when the spinning ends.
When the spinning ends, open the top lid and the interior lid. Then take out the depression cover and laundry after the spinning drum has stopped rotation completely.
Note: Refer to the Notes on Spinning carefully. |
|
If you need | , please check the connection |
between the water hose and filling inlet. |
|
Install the water inlet hose |
|
Water inlet hose |
|
The water hose should be connected | Water inlet entrance |
as shown in the right figure. |
Notes on Spinning
Use the
Please put in the gland properly even if the laundries
quantity is small.
.
Do not leave any articles above the depression cover.
Push Gland
Push
Proper The laundries | Proper No gland |
are slanting |
|