Using Method
4.Set ' heat selector knob' to select ' Strong dry' or ' Soft dry' level.
' Strong dry' level for large quantity and low room temperature.
' Soft dry' for non
Soft
Strong
Heat selector knob
5. Dry time settings
Select dry program according to clothes materials and |
|
|
| |
quantity, turn the timer knob to relative position. The | Do not point the | |||
dryer starts running. | cursor to blank. | |||
Please refer to page 10 ' Controlpanelandditsfunctionsns''. |
| OFF | Cooling | |
60 | 0 | |||
and page 12 ' Dry Capacity ¡¤Dry Time Reference Table' . |
| |||
Air drying |
|
| ||
| 40 |
|
| |
20
40
Caution: Dry timing knob cursor shouldn't be set at the blank area, as indicated in the right figure.
Do not
point the
cursor to
blank
20
OFF 0
220
200
180140
160
60
80
100
120
6. Do not take the laundry out until drying process is done
The last 20 minutes of hot air drying is cooling to reduce the temperature of laundry inside the drum.
To take the laundry out during drying, please run cooling operation first since the temperature inside the drum must be high.
Static electricity, due to friction, will be generated on clothes made of chemical fibre after dried. You can feel it when taking them out, which is normal and shall not to be worried about.
7. Unplug the power cord
Please hold plug to unplug power cord from
a receptacle. Do not pull electrical wire directly to prevent internal breakage or bad connection.
8. Clean filters
Clean the lint filter after every load and before each use. A clean filter ensures sufficient drying. A layer of lint on the filter reduces airflow through the clothes and prolongs drying time
Refer to the instructions on page 13.