AEG 57700 operating instructions Replace the interior light

Something not working?

Symptom	Possible cause	Solution
The dryer terminates the		Select time program or
drying process automatically:	Too dry or too little
		higher drying stage (e.g.
END is displayed shortly after	laundry filled-in for the
		EXTRA DRY instead of
program start; no display of	selected program
		CUPBOARD DRY)
the extent of drying
The drying process takes		Check the program
	SPECIAL CARE button	selection: SPECIAL CARE
unusually long. 4.5 hours
	pressed and too much	button appropriate only
after the beginning of the
	laundry filled-in	for laundry amounts up
drying process:
		to 2.5kg
- END display flashes
- acoustic signal sounds	Too much laundry	Reduce the amount of
- discontinuation of the	filled-in	laundry filled-in
drying process		Pre-dry the laundry more
- error code C6 is displayed	Laundry too damp
		thoroughly

If you do not find the required information in this manual to remedy a disturbance, please call the customer service.

Replace the interior light

0A replacement bulb can be purchased through your local AEG Service Force Centre (Part No: 647072580).

1 Warning! Never use standard light bulbs in your Lavatherm.

0Isolate the appliance from the mains supply.

0Screw-off the bulb cover. (The bulb is located at the top behind the door; see Front view).

0Replace the defective bulb.

0Screw-on the bulb cover.

1 Warning! For safety reasons the bulb cover must be screwed-on. The dryer must not be operated, without the cover in place.

30