Meter | Case | Installation | Hardware | |
Contents: |
| Tools | Required: | |
3/8 x | 16 lock | nut (1) | 9/16 | socket and drive |
Installation Instructions:
1.Remove meter case access door.
2.InstaII 3/8 lock nut onto security bolt and tighten securely.
3.InstaII meter case access door.
INSTRUCTIONS TO CHANGE THE NUMBER OF COIN SLIDE INSERTIONS TO START APPLIANCE,
1.Disconrtect power from machine,
2.]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm drops into cam notch (Fig. 2),
3.Lift Adjusting Tab away from cam with finger and turn Tab to desired number. Make sure Tab\ locks into place in new position,
4.]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm is on top of lab to assure that both mechanism switches are open (Fig, 3)
5.Reconnect power to machine,
| NOTCH |
| FINGER TO | ||
|
| LIFT | TAB | ||
| ,\ |
|
| ||
\ |
| _ADJU ST:tENT | 2/ |
| |
\ | _ | TAB |
| ||
\ |
|
| __ SWITCH LEVER AP$1 | ||
|
|
|
|
| |
I CLOCKWZSE
DIRECTION
FIGURE | 2 | FIGURE | 3 |
|
|