Se ,ceYr IG
Instruction
Sheet |
|
|
|
| 16008915 | |
|
|
|
| |||
|
|
|
|
|
| |
|
| This instruction sheet is to be used with : |
| |||
REPAIR PART NO. : 12001454, 12001725 |
|
| ||||
DESCRIPTION: Machine Control Board Kit |
| i | ||||
| II II II | II |
|
|
| |
This kit | contains: |
|
|
|
| |
22002988 | Machine | Control Board | 16002292 | Schematic | ||
22002335 | Jumper | Wire (Red | Wire No. 3) | 16008915 | Instruction Sheet | |
22002281 | Pilot Lamp (YellowI | based)I |
|
| ||
The following chart will depict which components apply to the washer you are servicing.
Model Number | Prior to Series 17 | Series 17 & Later |
MAH300OAWA | A | B |
MAI_000AWQ | A | B |
MAH3000A_ | A | B |
=Use all components and follow instruction steps 1 - 11 below. B = Use only the 22002988 board and follow instruction steps 1,2,
84.iDE BOARD - LEFT
9, 10 & 11 below.
Procedure:
1.unplug the washer.
ZRemove the three screws securing the rear console cover plate to the console and lay the console forward carefully onto a sen,ice blanket on the top cover.
3.Locate the ON Lightin the console and remove the Black No. 3 wireand theWhite ,'Jo. 11
wire from the signal lamp assembly. Unsnap and discard the ON Light lamp assembly.
4.Fold the Black No. 3 wire back and tape the wire to the main harness out of the way.
5.Locate and remove connector P7 from the left side of the Machine Control board.
6.Insert the jumper wire (Red Wire No. 3), found in the service repair assembly, into position number 5 of the P7 connector, then reconnect the P7 connector beck onto the Machine
Control Board.
7.Remove the Yellow based indicator lamp found in the service assembly and position the
lamp where the previous ON Light lamp assem- bly was previously removed. Then snap the new lamp assembly into the console.
8, Connect the White No. 11 wire and the Red No. 3 wire to the new yellow based lamp assembly.
9, Remove the existing electrical schematic taped to the rear wall of the console and replace
with the electdcal schematic found in the service assembly.
lO,Reposition the console into the updght position on the topcover and secure the three
screws fastening the console to the rear console cover plate.
11.Replacement is complete.