When moving the
washer/dryer...
•Disconnect the power supply cord, then tape securely to the washer/dryer.
•Shut off the gas supply valve in the gas supply line.
•Disconnect the flexible gas connector and fittings from gas supply line and cap the gas supply line.
•Tape the flexible gas connector to back panel of the washer/dryer. DO NOT DISCONNECT THE FLEXIBLE GAS CONNECTOR FROM THE WASHER/DRYER.
•Unscrew the cable bracket from the wall stud or concrete wall. Save the bracket and four screws.
•Tape the drum to the front panel. Tape the lint screen in place. Tape the dryer door closed.
•Wedge a blanket between the tub ring and cabinet top to restrict tub movement.
Before installing the washer/dryer in your new home, check with your gas supplier or dealer to see that your dryer is equipped with the correct burner for the particular type of gas in your new home. Burner information may be found on the rating plate in the door well of the dryer.
If washer/dryer does
not operate properly...
Check the following to be sure that:
1.Electric supply is connected.
2.House fuse or circuit breaker is intact and tight.
3.Washer lid or dryer door is closed.
4.Controls are set in a running or “ON” position.
5.Dryer start button has been firmly pushed.
6.Make sure shipping strap has been completely removed and was used to secure the drain hose to the tub or standpipe.
7.Gas shutoff valve is open in supply line.
If you need
assistance...
The Whirlpool Customer Interaction Center will answer any questions about operating or maintaining your washer/dryer not covered in the Installation Instructions. The Whirlpool Customer Interaction Center is open
24 hours a day, 7 days a week. Just dial
When you call, you will need the washer/dryer model number and serial number. Both numbers can be found on the model/serial rating plate located in the door well behind the dryer door and on front of opening.
If you need service...
In the event that your Whirlpool appliance should need service, call the dealer from whom you purchased the appliance or a
Maintain the quality built into your Whirlpool appliance — call a Whirlpool- designated service company.
1" x 4" x 24" mounting board secured across two wall studs or on a concrete wall.
Four screws secure cable bracket to mounting board.
The exhaust requirements, cable requirements and wiring diagram are located on the back of the access panel.