If washer/dryer does
not operate properly...
Check the following to be sure that:
1.Electrical supply is connected.
2.House fuse or circuit breaker is intact and tight.
3.Washer lid or dryer door is closed.
4.Controls are set in a running or “ON” position.
5.Dryer start button has been firmly pushed.
6.Make sure shipping strap has been completely removed and was used to secure the drain hose to the laundry tub or standpipe.
When moving the
washer/dryer...
•Disconnect the power supply cord, then tape securely to the washer/dryer.
•Tape the drum to the front panel. Tape the lint screen in place. Tape the dryer door closed.
•Wedge a blanket between the tub ring and cabinet top to restrict tub movement.
•Turn front leveling legs all the way in.
If you need assistance...
The Whirlpool Customer Interaction Center will answer any questions about operating or maintaining your washer/dryer not covered in the Installation Instructions. The Whirlpool Customer Interaction Center is open 24 hours a day, 7 days a week. Just dial
When you call, you will need the washer/dryer model number and serial number. Both numbers can be found on the model/serial rating plate located in the door well behind the dryer door on front of opening.
If you need service...
In the event that your Whirlpool appliance should need service, call the dealer from whom you purchased the appliance or a
Maintain the quality built into your Whirlpool appliance — call a Whirlpool- designated service company.
Part No. 3397616 Rev. B
© 2000 Whirlpool Corporation
® Registered Trademark of Whirlpool, U.S.A.
CORPORATION
Prepared by Whirlpool Corporation, | Printed in U.S.A. | |
Benton Harbor, Michigan 49022 | ||
|