Humminbird 128 manual Inside the Hull Installation, Step One Determine the Mounting Location

Page 10

INSTALLATION

INSIDE THE HULL INSTALLATION

INSIDE THE HULL INSTALLATION

Inside the hull installation requires the mount system and control head be installed and operational. See Installing the Control Head for instruction on installing the unit.

Inside the hull mounting generally produces good results in single thickness fiberglass-hulled boats. Humminbird cannot guarantee depth performance when transmitting and receiving through the hull of the boat since some signal loss occurs. The amount of loss depends on hull construction and thickness, and the installation.

This installation requires slow-cure two-part epoxy. Do not use silicone or any other soft adhesive to install the transducer, as this material reduces the sensitivity of the unit. Five minute epoxy has a tendency to cure before all the air bubbles can be purged.

Step One - Determine the Mounting Location

Begin the transducer installation by determining where inside the hull to install the transducer. Consider the following to find the best location:

Observe the outside of the boat hull to find the areas that are mostly free from turbulent water. Avoid ribs, strakes, and other protrusions as these create turbulence (Figure 14).

As a general rule, the faster the boat can travel the further aft and closer to the centerline of the hull the transducer has to be located to remain in contact with the water at high speeds.

Step Two - Test the Mounting Location

There is no opportunity for adjustment after the transducer glued

in place. Therefore, it is best to perform a trial installation on inside the hull transducers first, and run the boat at high speeds to determine the best mounting area.

1.At the identified mounting location, lay the transducer body face down with the pointed end towards the bow.

2.Fill the hull with enough water to submerge the transducer body. Use a sand filled bag or other heavy object to hold the transducer in position.

The transducer cannot transmit through air. The water purges any air from between the transducer and the hull and fills any voids in the coarse fiberglass surface.

Image 10
Contents Page Installation Overview AccessoriesParts Supplied Determining How to Mount the Transducer Trolling Motor Mounting Alternate Transducers and Mounting MethodsPortable Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerStep Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomStep Six Route the Cable Step One Determine the Mounting Location Inside the Hull InstallationStep Two Test the Mounting Location Step Three Permanently Mount the Transducer Step One Determine Where to Mount Control Head InstallationStep Two Connect the Power Cable to the Boat Step Three Drill the Mounting Holes Step Four Run the CablesStep Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation Testing the Installation What YOU see ON-SCREEN Simulator OperationInterpreting the ON-SCREEN Information Page Control Functions Menu Functions SenstivityDepth Range Zoom Depth Alarm Fish AlarmUsing Diagnostic Fish ID