Linear LDCO800 installation instructions Battery, Backup, Unit

BBU			PRODUCT DESCRIPTION	FEATURES
			The Model BBU Battery Backup Unit is designed to provide DC power for Linear’s
			Model LDCO800 Garage Door Operator during AC power outages.	INTERNAL SOUNDER
BATTERY			The BBU contains two rechargeable batteries that are maintained and charged by	3 BEEPS EVERY MINUTE = FAILED BATTERY TEST
			the LDCO800 operator. If the installation’s AC line power is interrupted, the BBU will
BACKUP			power the operator for up to 24 hours. The duration of the operator’s battery backup	MOUNTING TABS (3)
			will depend on the number of times the garage door is cycled without AC power. The
UNIT
			batteries will be fully recharged within 48 hours after AC power is restored.
Installation Instructions			The BBU contains an internal sounder to indicate the current status of the battery
			unit. The unit regularly performs a self-check routine while AC power is present. If the	MOUNTING SCREWS (3)
			batteries test low or dead, the unit will sound three beeps every minute to indicate
For Use with Model LDCO800			that service is required.
Garage Door Operators			Every LDCO800 is compatible with the BBU. The operator now has three pre-drilled	WIRING HARNESS
			holes in the chassis to mount the BBU and a connector for the BBU on the controller
			board.
			For retrofi t installations, replace the LDCO800 operator’s controller board with a newer
	USA & Canada (800) 421-1587 & (800) 392-0123		Model HAE00061 controller board that has the BBU connector. Refer to the mounting
	(760) 438-7000 - Toll Free FAX (800) 468-1340		template supplied to drill three holes in the chassis of the operator to mount the BBU.
	www.linearcorp.com
REMOVE OPERATOR COVER			INSTALL BATTERY BACKUP UNIT IN OPERATOR	CONNECT POWER WIRES
1	UNPLUG THE OPERATOR BEFORE PROCEEDING !!!		USE THE THREE SCREWS TO ATTACH	REMOVE JUMPER PLUG FROM
			THE BATTERY BACKUP UNIT TO	CONTROLLER BOARD'S 3-WIRE HARNESS
			THE OPERATOR BASE PLATE	(SAVE THE JUMPER PLUG)
			FOR RETROFIT INSTALLATIONS,
			REFER TO MOUNTING TEMPLATE
				CONNECT THE 3-WIRE HARNESS TO
2				THE BATTERY BACKUP 3-WIRE HARNESS
LOOSEN THE
FOUR COVER				JUMPER PLUG
SCREWS				NOTE: THE JUMPER PLUG MUST
		3		REMAIN IN PLACE UNTIL THE
				BATTERY BACKUP
		REMOVE THE		UNIT IS INSTALLED
		OPERATOR'S	THE BATTERY BACKUP
		COVER	UNIT CAN BE INSTALLED
			WHILE THE OPERATOR IS
			MOUNTED OR WHILE THE
			OPERATOR IS ON THE FLOOR
REPLACE OPERATOR COVER			TEST OPERATOR	LINEAR LIMITED WARRANTY
				This Linear product is warranted to the original consumer against defects in material and workmanship for 1 year. Linear will repair,
				or at its option, replace, any device that it finds requires service under this warranty, and will return the repaired or replaced device
			1 BE SURE TO LET THE BATTERY	to the consumer at Linear’s cost. Devices must be sent to Linear for service at owner’s expense. This warranty does not apply to
1	REPLACE THE	2		damage to the product from negligence, abuse, abnormal usage, misuse, accidents, normal wear or tear or due to failure to follow
			BACKUP UNIT CHARGE FOR
				Seller’s instructions, or arising from improper installation, storage or maintenance. In no event will Linear be responsible for incidental,
	OPERATOR'S	TIGHTEN THE FOUR	48 HOURS BEFORE TESTING	compensatory, punitive, consequential, indirect, special or other damages. The remedies provided by this warranty are exclusive.
		COVER SCREWS
	COVER			Some states do not allow the exclusion or limitation of incidental and consequential damages, so the above limitation or exclusion may
				not apply to you. Any warranties implied by law are limited to the time periods set forth above. Some states do not allow limitations on
				how long an implied warranty lasts, so the above limitation may not apply to you.This warranty gives you specific legal rights, and you
				may also have other rights which vary from state to state.
				For warranty service and shipping instructions contact Linear at the phone number shown below. In order to be protected by this
				warranty, save your proof of purchase and send a copy with equipment should repair be required. All products returned for warranty
				service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA#
				and other important details.
			2	This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with
			UNPLUG THE	the manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and found to comply
				with the limits for a Class B computing device in accordance with Part 15 of FCC Rules, which are designed to provide reasonable
			OPERATOR
				protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a
				particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning
			3 TEST RUN THE OPERATOR	the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
				• Relocate the Console away from the TV/radio receiver.
			(THE OPERATOR'S LAMP WILL NOT LIGHT)
				• Plug the Console into a different wall outlet so that the Console is on a different branch circuit.
			4 PLUG THE OPERATOR BACK IN	• Re-orient the TV/radio antenna.
				• If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
				Copyright © 2012 Linear Corporation	232338 B