Radio Shack BTX-124 owner manual Preparation, Charging the Battery Pack

Page 6

PREPARATION

Before you use the transceiver, you must be properly licensed by the FCC. If you are licensed to use one or both of the supplied frequencies, you can im- mediately use the transceiver.

If you are licensed on different frequen- cies, your local RadioShack store must send the transceiver to an authorized service facility to have the frequencies programmed into the transceiver. You must tell the store the frequency you are licensed for and any desired CTCSS tone (the factory preset is 100.0 Hz). See “Why Use CTCSS?” on Page 11 for more information about CTCSS.

CHARGING THE BATTERY PACK

You must charge the battery pack with the supplied battery charger before you use it the first time, and whenever the battery becomes low.

You can charge the battery pack with it attached to the transceiver or removed.

To attach the battery pack, slide it onto the transceiver. To remove the battery pack, press down and slide RELEASE in the direction of the arrow, then slide off the pack.

ILLUSTRATION

Follow these steps to charge the battery pack.

1.If the transceiver is on, turn VOL counterclockwise until it clicks to turn it off.

ILLUSTRATION

2.Plug the charger’s barrel plug into the CHRG jack on the side of the

6

Image 6
Contents BTX-124 Features Contents FCC Regulations FCC License RequiredFCC Part 90 Rules Page Charging the Battery Pack PreparationIllustration Using the Belt Clip Connecting AN Antenna Using AN External MicrophoneOperation WHY USE CTCSS? Operational HintsAdditional FCC Regulations Maintenance Specifications TransmitterFactory Defaults RadioShack Division of Tandy Corporation Fort Worth, Texas
Related manuals
Manual 16 pages 12.79 Kb