Radio Shack 21-1703 A manual Setup, Attaching the Microphone Holder

Page 4

Setup

Setup

Attaching the Microphone Holder

You can attach the microphone holder to either side of the transceiver or to another location in your vehicle.

To attach the holder to either side of the transceiver, secure the holder to the side using the supplied 3mm self-tapping screws, and spring washers.

Holder

Spring washer

3mm self-tapping screw

To attach the holder to another location in the vehicle, such as the dashboard, follow these steps.

1.Using the holder as a template, mark the positions for the mounting screw holes at the desired location.

2.At each marked position, drill a hole slightly smaller than the supplied mounting screws.

3.Attach the holder at the mounting location using the supplied 3mm machine screws, spring washers, plain washers, and nuts.

Note: If you cannot reach behind the mounting surface to attach the nuts on the machine screws, use the supplied 3mm plain washers and self-tapping screws.

4

Image 4
Contents Mini Mobile CB Radio What’s IncludedProduct Features Setup OntentsProduct Features Product FeaturesOther Features Setup SetupAttaching the Microphone Holder Mounting the Transceiver Connecting an Antenna Connecting the Microphone Connecting an External SpeakerUsing Vehicle Battery Power Using the TransceiverReceiving Transmissions and Adjusting Squelch OperationOperation TransmittingUsing Common 10-Codes Operational HintsMaximum Range Additional Information TroubleshootingReducing Noise Care and Service Replacing the FuseSpecifications ReceiverRF Emissions Limited Warranty