Operation

1.Select a dry log or other wood stock to cut.

The stock should be no longer than the band saw table. Otherwise, the Saw Mill Guide Slide (1) may come out of the table guide slot. Check for preexisting nails or screws in the wood stock and remove before cutting.

2.Turn the Acme Screw Knob (8) counterclockwise to bring the Mounting Plate all the way back.

3.Place the Saw Mill on a flat surface to mount the wood stock.

4.Select the side of the wood stock for the first cut, and place the opposite side against the Mounting Plate (6).

5.Select holes on opposite ends of the Mounting Plate (6) to insert holding screws (not supplied). Screw in until wood stock cannot move. Use at least one screw at each end. See photo below-left.

Use 1-1/4 inch wood or sheet-rock screws. For irregular shaped wood stock, find a hole in the Mounting Plate that comes the closest to the surface of the wood stock. This will keep the wood stock more stable during cutting.

Mounting Plate (6)		Band Saw Head

Table Guide Slot

Up to 16 screw holes to mount wood stock

6.Place the Saw Mill, with attached wood stock, on the band saw table. Insert the Guide Slide (1) into the Table Guide Slot. See photo above-right.

7.Adjust the band saw head up to clear the wood stock being cut.

8.Determine the depth of cut by measuring from the saw blade to the outer edge of the wood stock.

If a deeper cut is to be made, turn the Acme Screw Knob (8) clockwise. If a thinner cut is to be made, turn Knob counterclockwise. As an estimate, each full turn of the Knob equals about 1/8 inch.

Caution: Always be aware of the depth of the mounting screws so the saw blade does not come into contact while cutting the wood stock.

SKU 92247

For technical questions, please call 1-800-444-3353

Page 6