7
Installation of the radio
You can either operate your ALBRECHT AE 5090 in the car or at home as a base station. For installation as a mobile station in the car, a mobile mount device is enclosed. Mount the set in such a way that it is not exposed to direct sunlight if possible, as this would lead to an increase in the temperature and can decrease the (set’s) working life. The set should also not be installed near a heater. Mount the set in such a way that it is exposed to as little vibration as possible.
The mobile fixing device should be attached to the dashboard, the tunnel slot or to any other suitable place using the enclosed tapping screws. Do not install the set in a place where it could cause injuries in the case of an accident (be particulary careful to ensure free leg movement). Take care not to damage any underlying wires during installation!
Then insert the radio into the mobile mount. Secure the set with the large knurled screws (using the enclosed plastic washers) firmly at the required angle.
Also mount the microphone hanger using the enclosed screws in an easily- accessible place.
In order to prevent interference to the vehicle electronics from transmission in the vehicle, please make sure to take any mounting instructions from the vehicle manufacturer for radios and antennas into account.
Power supply
Your AE 5090 receives power from the 2 pin
The red and black wires in the cable are for the power supply. The cable has a
However, You can choose from two methods when connecting to the power supply (red and black):
Example 1
The Radio should be able to be switched on and off at any time using the volume / on/off switch.
Connect up the red wire to the positive pole on the vehicle battery (or elsewhere in the vehicle’s electrical system with permanent plus) or to a 12 Volt external power supply unit.
Example 2
The set should be automatically switched on and off with the ignition.
Attach the red wire to a part of the vehicle electrical system which is interconnected to the ignition.
Connect up the black wire to the negative pole on the vehicle battery or the power unit or to a
7